Home > News > Technical documentation > How to deal with watermark and.....
Certifications
Best selling products
Contact us
Company Name: Qingdao Hongxiang Fanyu Trading Co., Ltd. Address: Room 308,  NO.877 A, Chongqing Road, Licang District, Qingdao City, Shandong Province, China  Tel: 0086-18300250107  
Contact Now
Share

News

How to deal with watermark and oxidation problems in Low-E glass products?

  • Author:Fanyu
  • Source:Www.glass.com.cn
  • Release on:2018-04-26
Recently, the weather has become warmer. After a customer's washing machine has been used for a winter season, how do watermarks and oxidation occur when processing Low-E glass?
The
suggestions below:
The
1. The cutter head has a large amount of oil and more oil. Causes incomplete cleaning of the washing stage. It is recommended to use a special cutting oil and reduce the amount of cutting oil to control its width within the range of removing the film.
The
2. The water quality of the edge mill water tank is lubricated with more microorganisms. It is recommended to add 8 4 disinfectant during maintenance. A water cycle is performed to eliminate microorganisms in the water.
The
3. Add a photo-electric induction flushing tube at the end of the edger to help improve the cleaning efficiency of the processor. As shown below:
The
4. The washing section should be cleaned with pure water. And pure water should be replaced at least 8 hours. Conventional tap water can be used for the grinding section. It is recommended to use pure water from the washing section.
The
5, after the film is completed, inglassPut part of the collection and placement, the glass should be isolated from each other by cork mats. The purpose of doing so is to further dry the internal water stains. As shown below:
The
6. Wash the ends of the clips. Wear a glass mask to prevent the spatter of the person's saliva. As shown below:
The
7. The entrance of the dryer bellows in the washing section should be covered with non-woven fabric or filter cotton, and should be replaced regularly. The reason is as follows: The dust in the factory is large, and if it is not cleaned or replaced for a long time, a watermark with dust will be formed on the glass surface.
The
8, the brush machine brush should be used soft brush, control the speed, the brush should be washed once a week with a high pressure water gun. Low-E washing speed is 2/3 of white glass.
The
9, to enhance personnel safety awareness, some process operations and personnel labor supplies need to use as required.
The
10, to enhance equipment maintenance awareness, the need for personnel in accordance with the maintenance schedule of regular maintenance and supervision and inspection.